Vibrerande trumlingsmaskin som rengör, tar bort rost och polerar metall.
Polerar detaljer upp till 25 cm långa.
Klarar att trumla upp till 8 kg vikt.
Trumlingsmedia
- Grovpolering, gjutjärn och stål
- Förpolering, keramiska koner
- Slupoleringskoner, används även på aluminium och mässing
- Valnötsskal, aluminium och mässing
- Trumlingsvätska, håller detaljer och media rena under poleringsprocessen.
- Motor 230 V AC
-
How to operate the Vibratory Tumbler
Step 1: Pre-clean and degrease items to remove oil and dirt.
Step 2: Fill the Tumbler Bowl about 2/3 full with polishing media. Various media are available for different jobs. Select the appropriate media and running time for the objects you wish to clean, deburr or polish. To remove rust, use Ceramic Triangles which are good for edges and holes. This gives a dull finish. To de-burr or polish, you can use either Plastic Cones, Walnut Shell or Porcelain Cylinder (see Types of Mediafor further information)
Step 3: Add work material parts to Vibratory Tumbler and cover the bowl. Do not over fill the Tumbler Bowl and do not exceed work weight limit of 8 kilos including media. Always do a test run on a few pieces of work material to test the media and running time before committing to a specific process. You can also add the Frost Vibro Liquid to clean and degrease old grimy hardware up to 50% faster.
Step 4: When the job is completed, you should wait at least 1 hour before opening the cover to allow the dust to settle. Vibratory polishers often use dry media that is light and dusty. If a lubricant is used, then the Drain Hose must be used to drain out any excess lubricant/water into a suitable container, preventing overflow.
Step 5: Check the work material to determine if the job is completed to your satisfaction. Repeat the process if required. If the work is completed, pour the media and parts from the bowl onto newspaper or a towel, remove the parts and dry them with a heat lamp or a hair dryer to avoid flash rust. Allow the wet media to air dry for future re-use.
